The Cpx−Cm−Hpp; Functions And Characteristics - Festo CPX-CM-HPP Electronic Manual

1. System summary
1.1 The CPX−CM−HPP

1.1.1 Functions and characteristics

1.1.2 Functions
Festo P.BE−CPX−CM−HPP−E N en 0910NH
The CPX−CM−HPP is an interface for electric positioning and
handling axes in the CPX System by Festo.
Programming of the CPX−CM−HPP is not required for this.
The following options are available for configuration:
MMI
FMT
EDS file
GSD file
Programming software of the CPX Front End Controller
The CPX−CM−HPP is designed for up to 4 axes. The axes are
connected on the front side via the CAN bus interface
(M9, 5−pin). The motor controllers are configured with the
Festo Configuration Tool FCT.
The motor controllers are controlled by a higher−order
controller via a CPX fieldbus node or through the CPX−FEC or
CPX−CEC−... controller integrated into the CPX terminal.
The CPX−CM−HPP merely passes on the I/O data.
The Festo data profile FHPP is used for communication.
The CPX −CM−HPP takes over the following functions:
Transfer of control and status data between the controller
and the connected motor controllers.
Malfunction management
1−3