Error Numbers - Festo CPX-CM-HPP Electronic Manual

4. Diagnosis and error treatment

4.2.3 Error numbers

Festo P.BE−CPX−CM−HPP−E N en 0910NH
In the CPX terminal, error messages are summarised into
error groups. You can find an overview of the error messages
of the CPX−CM−HPP in Tab. 4/2.
On the handheld type CPX−MMI, the error group of the
individual drives is displayed in the Diagnostics menu. If an
axis is selected, the fault signal of this axis is displayed in
plain text.
Since it can sometimes be defined in the drives whether a
status is a warning or an error, the status type of the message
in the CPX terminal cannot be uniquely specified.
The error numbers of the subsequent table can therefore be
for both errors and warnings.
The CPX−CM−HPP offers a 3−step error diagnosis:
1. The CPX−CM−HPP reports the error group no. to the CPX
master (error group no. 100 ... 109).
2. The precise error below the error group is displayed on
the 7−segment display of the CPX−CM−HPP and can be
read out with the CPX−MMI.
3. Additional diagnostics options are then possible via the
displayed error messages directly at the motor controller.
Further instructions can be found in the descriptions of the
respective motor controller.
The possible error causes named in the following table
do not claim to be complete. If in doubt, contact your local
Festo Service.
4−5