Contents and general instructions
Intended use
Festo P.BE−CPX−CMXX−E N en 0910a
The CPX−CMXX multi−axis interface documented in this
manual is intended exclusively for use in Festo CPX terminals
for installation in a machine or an automation control system.
The multi−axis interface CPX−CMXX permits coordination of
axis portals and positioning axes in conjunction with a
controller
The CPX terminal may only be used with the CPX−CMMX as
follows:
As specified in an industrial environment.
In its original condition without unauthorised
modifications. Only the conversions or modifications
described in the documentation supplied with the product
are permitted.
In perfect technical condition.
Only in combination with approved components,
e.g. CPX modules and motor controllers
(see chapter 1.2 and 1.3).
The limit values specified for pressures, temperatures,
electrical data, torques etc. should be observed.
Observe the regulations of the trade associations,
German Technical Control Board (TÜV), VDE stipulations or
corresponding national laws and regulations.
VII