Terminating Resistor - Festo CPX-CM-HPP Electronic Manual

2. Fitting and installation

2.4.2 Terminating resistor

2−8
A CAN bus terminating resistor is integrated into the axis
connection of the CPX−CM−HPP.
A CAN bus terminating resistor of 120 ohms must be installed
at the other end of the CAN bus. Depending on the drive,
this terminating resistor is integrated into the drive and
activated via DIP switches. If the drive does not have an
integrated terminating resistor, it must be manually connected
between the signals CAN−H (High) and CAN−L (Low).
Festo P.BE−CPX−CM−HPP−EN en 0910NH