Festo CPX-CM-HPP Electronic Manual page 24

1. System summary
CPX module
CPX−FB6 (Interbus)
CPX−FB11 (DeviceNet)
CPX−FB13 (PROFIBUS)
CPX−FB14 (CANopen)
CPX−FB23 (CC−Link)
CPX−FB32 (Ethernet/IP)
CPX−FB33, 34, 35 (PROFINET)
CPX−FB38 (Ethercat)
CPX−FEC
CPX−CEC−...
1)
Software version (SW) see rating plate
1−6
Required version
from Revision 22
from Revision 23
from Revision 16
Tab. 1/5: Required software versions
(Status December 2009)
Observe the following when using the CPX−CM−HPP:
When using two CPX−CM−HPP in one CPX terminal,
you must deactivate the diagnostic byte.
The CAN bus setting node ID: Default 1 cannot be
changed.
1)
Comment
not available
in preparation
in preparation
in preparation
in preparation
in preparation
in preparation
Festo P.BE−CPX−CM−HPP−E N en 0910NH