Festo CPX-CM-HPP Electronic Manual page 73

4. Diagnosis and error treatment
Error Designation and possible cause
no.
55 Checksum error
Internal error of the drive
56 Flash error
Internal error of the drive
Error in the controller (CPX error category 107)
70 Undervoltage logic power supply
Voltage lacking at the motor controller
2
71 I t Error (Overheating)
Too much load at the output of the
controller
72 Undervoltage or overcurrent of digital I/O
Internal error of the drive
73 Missing calibration data
Hardware fault at the motor controller
SD card defective
74 No user parameter set
Hardware fault at the motor controller
SD card defective
75 Hours−run meter missing
Hardware fault at the motor controller
SD card defective
Error in the measuring system (CPX error category 108)
80 Angle encoder error
Encoder or resolver defective
Cable of the angle transducer defective
Hardware fault at the motor controller
81 Old encoder parameter set (type CMMP−AS)
Internal error of the drive
82 Index pulse warning
Festo P.BE−CPX−CM−HPP−E N en 0910NH
Error handling
Contact Festo
·
Contact Festo
·
Check the power supply
·
Reduce the load.
·
Check controller parameters.
Contact Festo
·
Contact Festo
·
Contact Festo
·
Contact Festo
·
Check cable and replace if necessary
·
Contact Festo
·
Contact Festo
·
Contact Festo
·
4−9