Mounting - Festo CPX-CM-HPP Electronic Manual

2. Fitting and installation

2.2.2 Mounting

Festo P.BE−CPX−CM−HPP−EN en 0910NH
Mount the CPX−CM−HPP as follows:
1. Set the CPX−CM−HPP in the interlinking block. Make sure
that the corresponding grooves with the power contact
terminals on the bottom of the CPX−CM−HPP lie above the
contact rails.
2. Press the CPX−CM−HPP carefully and without tilting into
the interlinking block up to the stop.
3. Set the screws so that the self−cutting threads can be
used.
4. Tighten the screws by hand in diagonally opposite
sequence. Tightening torque 0.9 ... 1.1 Nm
2−5