ComAp IG-NT Reference Manual page 91

N
OTE
As there is always a connection between the N and PE wires at the mains side the
generator neutral contactors are always open when the mains breaker is closed.
Setpoint: WatchedContr
Group Process Control
Range [units] 0 .. 16 [min]
Related FW 3.0
Description This setpoint is used at redundant controller to specify the address of the related
main controller in
controller is not used as redundant or if
Group: Basic settings
Setpoint: Nomin Power
Group Basic Settings
Range [units] 1 .. 32000 [kW]
Related FW 3.0
Force value YES
possible
Description This setpoint is used for adjusting the gen-set nominal (rated) power, i.e. the
maximum allowed gen-set power level.
IS-NT controllers provide two independent power derating functions, which can be
used for derating of the gen-set according to an analog value (e.g. temperature).
See the setpoints
The nominal power or derated nominal power is used as the basis (100%) for gen-
set power protections, as the upper limit of the requested power in the parallel-to-
mains operation, for power management and other functions.
N
OTE
The actual setpoint units and range depend on setting of the Power format in
GenConfig.
Setpoint: Nomin current
Group Basic Settings
Range [units] 1 .. 10000 [A]
Related FW 3.0
Force value YES
possible
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
:
CAN-based rendundant
Derating1 strt
:
systems. Adjust this setpoint to 0 if the
wired rendundancy system
and Derating2 strt.
is used.
91