ComAp IG-NT Reference Manual page 321

from InteliMonitor using the "Remote switches" tool or via MODBUS using the
register #46361 and command #26.
N
OTE
See the Remote switches chapter in the InteliMonitor help for details about how to
control the output from InteliMonitor and the Modbus chapter in the latest
communication guide for information about control the output using Modbus.
Alarm output: Not lubricated
Related FW 3.0
Description The output is closed while there is the message Not lubricated present in the
alarm list, i.e. while the first lubrication cycle haven't been completed yet. The first
cycle occurs when the controller is switched on, when it is switched from OFF
mode to another mode or when the input
confirmed.
N
OTE
If the setpoint
off.
Alarm output: CAN2 bus empty
Related FW 3.0
The output is closed while there is the alarm CAN2 bus empty present in the
Description
alarm list, i.e. if the controller doesn't detect any other controller on the CAN2 bus.
This alarm can be disabled by the setpoint CAN2emptDetect.
Alarm output: Bus meas error
Related FW 3.0
Description The output closes when bus measurement protection is activated according to
description of Gener
Alarm output: ECU
Related FW 3.0
Description The output is closed while there is the ECU alarm present in the alarm list, i.e. if
an ECU unit is configured and it does not communicate with the controller
althought it is required to communicate.
Alarm output: SHBinCfgErr
Related FW 3.0
The output is closed while there is the SHBinCfgErr alarm present in the alarm list,
Description
i.e. if there is more than one controller on the CAN2 bus, which has configured
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
:
:
Prelubr time is set to 0 (OFF), the prelubrication function is switched
protect:BusMeasError
Emergency stop is released and
setpoint.
321