ComAp IG-NT Reference Manual page 154

Setpoint: #%LdResStop 2
Group Pwr Management
Range [units] #%LdResStrt 2
Related FW 3.0
Description This setpoint is used to adjust the load reserve for stop in relative mode. i.e.
mgmt mode
in the chapter
The currently active reserve set is selected by binary inputs
3 and
N
OTE
The reserve for stop must be always adjusted higher than the reserve for start.
Setpoint: #%LdResStrt 3
Group Pwr Management
Range [units] 0 ..
Related FW 3.0
Description This setpoint is used to adjust the load reserve for start in relative mode. i.e.
mgmt mode
in the chapter
The currently active reserve set is selected by binary inputs
3 and
Setpoint: #%LdResStop 3
Group Pwr Management
Range [units] #%LdResStrt 3
Related FW 3.0
Description This setpoint is used to adjust the load reserve for stop in relative mode. i.e.
mgmt mode
in the chapter
The currently active reserve set is selected by binary inputs
3 and
N
OTE
The reserve for stop must be always adjusted higher than the reserve for start.
Setpoint: #%LdResStrt 4
Group Pwr Management
Range [units] 0 ..
Related FW 3.0
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
.. 110 [%]
= REL (%) if the reserve set #2 is active. Learn more about reserves
Reserves, minimal running
Load res 4. If none of these inputs is active the set #1 is selected.
:
%LdResStop 3 [%]
= REL (%) if the reserve set #3 is active. Learn more about reserves
Reserves, minimal running
Load res 4. If none of these inputs is active the set #1 is selected.
.. 110 [%]
= REL (%) if the reserve set #3 is active. Learn more about reserves
Reserves, minimal running
Load res 4. If none of these inputs is active the set #1 is selected.
:
%LdResStop 4 [%]
power.
Load res
power.
Load res
power.
Load res
Pwr
2, Load res
Pwr
2, Load res
Pwr
2, Load res
154