ComAp IG-NT Reference Manual page 257

Binary input: AccessLock D#2
Related FW 3.0
This input forces the external local terminal or IntelliVision (display) #2 into
Description
monitoring mode.
N
OTE
Local display means that it is connected to dedicated RS485. There is possibility
to connect up to 2 external displays in IG-NT-BB or 1 in IG-NT. It is possible to
connect up to 3 external displays in IS-NT-BB and in IS-NT.
Binary input: AccessLock D#3
Related FW 3.0
Description N
OTE
For IS-NT and IS-NT-BB only.
This input forces the external local terminal or IntelliVision (display) #3 into
monitoring mode.
N
OTE
Local display means that it is connected to dedicated RS485. There is possibility
to connect up to 2 external displays in IG-NT-BB or 1 in IG-NT. It is possible to
connect up to 3 external displays in IS-NT-BB and in IS-NT.
Binary input: NeutralCB fdb
Related FW 3.0
Description This input is used for connection of the normally open feedback contact from the
Neutral contactor. If the input is active, the controller will consider the neutral
contactor as closed and vice versa. See also description of the setpoint
cont..
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
IssueActCallC5.
:
Setpoints changes are disabled.
Using control buttons on the panel is disabled even if the controller is in
MAN mode.
Change of controller mode is disabled.
:
:
Setpoints changes are disabled.
Using control buttons on the panel is disabled even if the controller is in
MAN mode.
Change of controller mode is disabled.
#Neutral
257