ComAp IG-NT Reference Manual page 219

controller. Bit0 represents LBO97, bit1 represents LBO98 etc..
N
OTE
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
Value: LogBout 8
Group Log bout
Units -
Related FW 3.0
Description This is a bit array containing status of logical binary outputs 113-128 of the
controller. Bit0 represents LBO113, bit1 represents LBO114 etc..
N
OTE
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
Value: LogBout 9
Group Log bout
Units -
Related FW 3.0
Description This is a bit array containing status of logical binary outputs 128-143 of the
controller. Bit0 represents LBO128, bit1 represents LBO129 etc..
N
OTE
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
Value: RemoteControl
Group Log bout
Units -
Related FW 3.0
Description This is a bit array containing status of the binary outputs
Remote
Group: Info
Value: Controller mode
Group Info
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
:
:
:
control8.
Remote control1 ...
219