ComAp IG-NT Reference Manual page 201

Value: Load char L2
Group Gener values
Units -
Related FW 3.0
Description Character of the generator load in the L2 phase. "L" means inductive load, "C" is
capacitive and "R" is resistive load (power factor = 1).
Value: Pwr factor L3
Group Gener values
Units -
Related FW 3.0
Description Generator power factor in phase L3.
Value: Load char L3
Group Gener values
Units -
Related FW 3.0
Description Character of the generator load in the L3 phase. "L" means inductive load, "C" is
capacitive and "R" is resistive load (power factor = 1).
Value: Gen freq
Group Gener values
Units Hz
Related FW 3.0
Description Generator frequency. The frequency is measured in the phase L3.
Value: Gen V L1-N
Group Gener values
Units V
Related FW 3.0
Description Generator voltage in phase L1.
N
OTE
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint
Value: Gen V L2-N
Group Gener values
Units V
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
:
VT ratio.
201