ComAp IG-NT Reference Manual page 235

Binary input: Oil press
Related FW 3.0
Description This input is to be configured to the physical binary input where engine oil
pressure binary sensor is connected. It provides following alarms:
N
OTE
If you use this logical binary input you do not need to configure any other
protection onto the respective physical binary input.
Binary input: AccessLock int
Related FW 3.0
Description This input forces the controller built-in terminal into monitoring mode.
N
OTE
As the IS-NT and IGS-NT-BB do not have built-in terminal, this input is assigned
to the terminal or IntelliVision (display) #1, which is supposed to be directly
attached to the controller or mounted close to it.
Binary input: AccessLock ext
Related FW 3.0
Description This input forces all external remote terminals into monitoring mode.
An external remote terminal is any device, which reads and/or writes data
from/into the controller and is connected to the controller via any other
communication bus than the dedicated terminal RS485 bus.
N
OTE
An example of such terminal is a PC with InteliMonitor, any kind of remote display
connected via CAN2 or a PLC connected to the RS485 and communicating via
MODBUS.
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
The input must not be active at stopped engine. If it is active, the
controller issues Sd Oil press B alarm.
The input must be active at running engine at latest in the moment when
the alarm blocking delay
the controller issues Sd Oil press B alarm.
:
Setpoints changes are disabled.
Using control buttons on the panel is disabled even if the controller is in
MAN mode.
Change of controller mode is disabled.
:
Setpoints changes are disabled.
Executing commands is disabled.
Change of controller mode is disabled.
:
RunOnlyBlkDel1 has elapsed. If it is not active,
235