ComAp IG-NT Reference Manual page 276

the chapter
Analog input: PowerDerating2
Related FW 3.0
Description This is the input into the Power derating block #2. See details about the function in
the chapter
Analog input: MLC:AnExSysBld
Related FW 3.0
Description This functional input is used for requesting the system baseload externally by an
analog input. The setpoint
the system baseload from this input.
N
OTE
This logical analog input must be configured at each gen-set to the identical
source. The shared peripherial modules can be used to distribute the value over
the controllers via the CAN2 bus. See the note in the description of the setpoint
SysBaseLdMode.
Analog input: MPF:AnExSysBPF
Related FW 3.0
Description This functional input is used for requesting the system power factor externally by
an analog input. The setpoint
the requested system power factor from this input.
N
OTE
This logical analog input must be configured at each gen-set to the identical
source. The shared peripherial modules can be used to distribute the value over
the controllers via the CAN2 bus. See the note in the description of the setpoint
SysBaseLdMode.
Analog input: Cyl temp 1
Related FW 3.0
Description Logical analog input for cylinder temperature #1. Used for computing of values
Cyl
N
OTE
Available in IS-NT only.
Analog input: Cyl temp 2
Related FW 3.0
Description Logical analog input for cylinder temperature #2. Used for computing of values
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
Power derating.
Power derating.
SysBaseLdMode
:
:
aver, T Cyl max, T Cyl min.
:
must be set to EXTERNAL to read
SysBasePFMode must be set to EXTERNAL to read
T
T
276