ComAp IG-NT Reference Manual page 295

Binary output: Prelubr pump
Related FW 3.0
Description This output can be used for periodic lubrication of the engine while the engine is
not running. The output is periodically closed for
Prelubr
The output opens immediately when
controller is switched to OFF mode.
N
OTE
The engine must be equipped with an external electric motor-driven oil pump to
allow this function.
Binary output: FltResButnEcho
Related FW 3.0
Description This output provides 1s pulse when:
Binary output: HrnResButnEcho
Related FW 3.0
Description This output provides 1s pulse when:
Binary output: StartButnEcho
Related FW 3.0
Description This output provides 1s pulse when:
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
pause.
:
Fault reset button is pressed on the controller front panel or
Fault reset button is pressed on any of external local/remote terminals or
fault reset command is received via communication line or
the input FaultResButton
Horn reset button is pressed on the controller front panel or
Horn reset button is pressed on any of external local/remote terminals or
horn reset command is received via communication line or
the input HornResButton
Start button is pressed on the controller front panel or
Start button is pressed on any of external local/remote terminals or
start command is received via communication line or
the input StartButton
Prelubr time
Emergency stop
is activated.
is activated.
is activated.
and then opened for
is activated or if the
295