ComAp IG-NT Reference Manual page 104

Setpoint: DispBklStrtOff
Group Basic settings
Range [units] DISABLED, ENABLED [-]
Related FW 3.0
Force value YES
possible
Description If this setpoint is in ENABLED position the display backlight is temporarily
switched off during gen-set start.
Setpoint: FastHistPeriod
Group Basic settings
Range [units] 100 ms, 300 ms, 500 ms, 1 s, 3 s [-]
Related FW 3.0
Description This setpoint adjusts the period with which fast history records are written. Fast
history is triggered if level 2 alarm (for more information on alarm levels please
refer to
from
records.
Setpoint: ConvCoefPulse1
Group Engine Params
Range [units] 1 .. 6500 [-]
Related FW 3.0
Description This setpoint adjusts the rate of increasing of the PulseCounter #1 module. The
module counts pulses at the input
reaches value given by this setpoint, the counter value PulseCounter 1 (in the
group Statistic) is increased by 1 and input pulses counter is reset to 0. Both
counter value and input pulses counter are stored in the nonvolatile memory.
Setpoint: ConvCoefPulse2
Group Basic settings
Range [units] 1 .. 6500 [-]
Related FW 3.0
Description This setpoint adjusts the rate of increasing of the PulseCounter #2 module. The
module counts pulses at the input
reaches value given by this setpoint, the counter value PulseCounter 2 (in the
group Statistic) is increased by 1 and input pulses counter is reset to 0. Both
counter value and input pulses counter are stored in the nonvolatile memory.
Inteli NT MINT, SW Version 3.0, ©ComAp –May 2013
IGS-NT-MINT-3.0 Reference Guide.PDF
this section) is issued and the engine is running (at least one condition
this list is fullfiled). For any setting of this setpoint Fast History contains 50
PulseCounter 1 and if the input pulses counter
PulseCounter 2 and if the input pulses counter
104