Connecting Devices With A Serial Or Parallel Interface; Connecting The Monitor - Fujitsu LAN Console Installation, Configuration And Operation

Overview of connections
4.3.3 Connecting devices with a serial or parallel
interface
Ê Connect the data cable to the external device.
Ê Connect the data cable of the external device to the corresponding interface
on the system unit.
I
Most devices that you connect to the serial or parallel interface require
special drivers. Many drivers are already included in your operating sys-
tem. If the required driver is not on the hard disk, you have to install it
from the diskette or CD, which was supplied with the device or with the
application program.
4.3.4

Connecting the monitor

The monitor is not part of the scope of delivery and has to be ordered sepa-
rately.
Ê Prepare the monitor as described in the Operating Manual for the monitor.
Ê Insert the data cable for the monitor into the monitor port on the system unit
(video connector J5 as shown in figure 6).
Figure 8: Monitor connection
Ê Connect the power cable for the monitor, depending on the plug, to the mon-
itor socket on the system unit (1) or to the grounded power outlet (2).
18
LAN Console
2
1
U41224-J-Z916-1-76