HEIDENHAIN MANUALplus 620 Technical Manual page 1391

7.11.3 Spindles
Subkinematics (as
of NC SW
548 328-03)
January 2012
Settings in the configuration editor
Axes
Settings
SpindleAxis
[Key name of the spindle axis]
CfgMachineTable
Aggregates
General
CfgGlobalProperties
freezeVconst
In MP_sysKinSimple, enter the key name of the subkinematics for the tool
spindle.
MP_sysKinSimple
Subkinematics of the tool spindle
Available from NCK software version: 597 110-04.
Format: Selection menu
Selection: Key names from Channels/Kinematics/CfgKinSimpleModel
Default: K_WP_S1
Access: LEVEL3
Reaction: RESET
The key name of the subkinematics for the machine base is to be entered in
MP_basisTransKinSim.
MP_basisTransKinSim
Subkinematics of the machine base
Available from NCK software version: 597 110-04.
Format: Selection menu
Selection: Key names from Channels/Kinematics/CfgKinSimpleModel
Default: K_WP_S1_BASE
Access: LEVEL3
Reaction: RESET
7.11 Additional Parameters for Lathes
sysKinSimple
basisTransKinSim
sys
basisTrans
MP number
300703
300704
300701
300702
601808
1391