HEIDENHAIN MANUALplus 620 Technical Manual page 1604

1604
MP_unique
Defines whether only unambiguous values are allowed in the
column (optional)
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: FALSE
Values may occur more than once
TRUE
Only unambiguous values allowed
Default: No value, parameter optional (= FALSE)
Access: LEVEL3
Reaction: NOTHING
MP_readonly
Write protection on column entry
If the attribute is set to TRUE, the value assigned when
inserting the line cannot be changed. If the attribute is not set
or set to FALSE, values may be overwritten.
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: FALSE
Values may be overwritten
TRUE
Values are write-protected
Default: No value, parameter optional (= FALSE)
Access: LEVEL3
Reaction: NOTHING
MP_unitIsInch
Values in inches (optional)
If lengths and feed rates are to be specified in the column in a
definite unit of measure, enter TRUE here for values in inches
and FALSE for values in mm. If the parameter is not set, the unit
of measure is taken from the corresponding table.
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: FALSE
Column entry in mm
TRUE
Column entry in inches
Default: No value, parameter optional
Access: LEVEL3
Reaction: NOTHING
If, in the table editor, you want to display language-sensitive texts for columns,
you must insert a CfgColumnText data object. However, this object is not
absolutely necessary. If the object is missing, the column name is shown in
the dialog line in the table editor. When inserting, the same column name
must be given as in CfgColumnDescripton.
HEIDENHAIN Technical Manual MANUALplus 620