HEIDENHAIN MANUALplus 620 Technical Manual page 1793

9.10 The Transfer Mode of Operation
January 2012
The Transfer mode is used for data backup and data exchange with other IT
systems. NC program files, parameter or tool files are transferred.
The data is transmitted through Ethernet-based networks or via the USB
interface. The control supports the networks provided by WINDOWS. The
control uses the "dual-window concept." This means you see the files of your
own system in the left and the files of the other side in the right half of the
screen.
You send data from the control or receive data from the other side. This is
always initiated by the control.
Use TNCremoNT if you want to send files from a PC to the control or
"collect" them from the control. TNCremoNT is available free of charge from
HEIDENHAIN.
The following transfer functions are available:
Programs – Transmitting and receiving files
Back up parameters – Creating, transmitting and receiving
Restore Parameters – Reloading the parameter backup files
Backup tools – Creating, transmitting and receiving
Restore Tools – Reloading the tool backup files
Service – Creating and transmitting service data
Data Backup – Backing up all data in a project folder
Free external – Freely selecting program files on a USB storage device
Miscellan. functions – Importing the cycle programs and DIN programs of
the MANUALplus 4110 and DIN PLUS programs of the CNC PILOT 4290
Note
For detailed information and descriptions of the Transfer mode of operation
of MANUALplus 620, refer to the User's Manual for the control.
9.10 The Transfer Mode of Operation 1793