HEIDENHAIN MANUALplus 620 Technical Manual page 1516

Hide thumbs Also See for MANUALplus 620:

8.3 Configuring PLC Input/Output Systems

Settings in the configuration editor

CfgPlcPeriphery

You can configure the PLC input/output systems with HSCI interface (PL 6xxx,

UEC 11x, MB machine operating panel with connected HR handwheel) and

the PROFIBUS components using the IOconfig PC software.

The components of an HSCI/PROFIBUS system are specified in a project with

IOconfig and their arrangement is described. On the basis of this data,

IOconfig generates the IOC file (*.IOC), which contains all relevant

configuration data.

Then you transfer the IOC file to the control. Enter the path/name of the

project file in the MP_iocProject parameter. With the next start-up, the IOC

file is then read in and evaluated by the control.

All information required for using the IOconfig PC software and configuring

HSCI and PROFIBUS components is contained in the IOconfig Technical

Information, which is available for registered customers from the

HEIDENHAIN FileBase on the Internet.

MP_iocProject

Configuration file for IOC hardware (HSCI and PROFIBUS

Available from NCK software version: 597 110-03.

Max. 260 characters

Path and file name of the IOC project file, for example:

%OEM%\plc\ioc\project.ioc

HEIDENHAIN Technical Manual MANUALplus 620