HEIDENHAIN MANUALplus 620 Technical Manual page 1765

USB devices on the
control
USB devices tested
by HEIDENHAIN
USB device Manufac-
turer
Floppy disk drive TEAC
Floppy disk drive TEAC
CD-ROM drive TEAC
CD-ROM drive FREECOM
Hard disk UNKNOWN USB to IDE Converter
Memory stick TrekStor
Memory stick QDI
Memory stick Transcend
Memory stick Transcend
Memory stick Generic
January 2012
The USB interface of the control allows for convenient and fast exchange of
data. You can connect USB block devices, such as memory sticks, hard disks,
CD-ROM drives, to your control via the USB interface without having to reboot
the system. The data media can be accessed immediately after connection.
The control supports the following USB block devices:
Floppy disk drives with the FAT/VFAT file system
Memory sticks with the FAT/VFAT file system
Hard disks with the FAT/VFAT file system
CD-ROM drives
The control does not support USB devices with other file systems (e.g. NTFS).
If you try to connect such devices, the control will issue an error message.
Note
It should basically be possible to connect all USB block devices with the
above-mentioned file system to the control. If you nevertheless encounter
problems, please contact HEIDENHAIN.
A variety of USB storage media from different manufacturers is available on
the market. It may happen that a USB device is not identified correctly by the
control. The USB devices listed in the table below were tested by
HEIDENHAIN for proper functioning in conjunction with the control (numerous
other USB devices are supported by the control, but you should test them for
proper functioning on the control before using them):
Model designation
TEAC FD-05PUW
TEAC FD-05PUB
USB CD-ROM 210 PU
USB2-IDE Controller
USB MiniStick
UNKNOWN
TS512MJFLASH
Flash Disk
Mass Storage Device
9.4 The USB Interface of the Control (USB 2.0)
VendorID ProductID
0644 0000
0644 0000
0644 1000
07ab fc02
05e3 0702
0c76 0007
0c76 0005
058f 9380
0ea0 2168
058f 9384
Revision
0.00
0.00
1.33
11.10
0.02
1.00
1.00
1.00
2.00
1.05
1765