HEIDENHAIN MANUALplus 620 Technical Manual page 1407

Hide thumbs Also See for MANUALplus 620:

Tool pocket preset

January 2012

With the machine parameter MP_setToolPlace under CfgPlcSymName, a

symbolic variable name can be defined under which the PLC can preset a tool

pocket. The user interface evaluates the request, inserts the tool in the tool

pocket and displays the T number. As an acknowledgment, the defined tool is

overwritten by the NC in the variable with (0). Then, as with a normal tool

change, the tool call strobe is set and the requested T number is transferred.

If the tool change cannot be performed, a (–1) is entered. At present the tool

preset by the PLC is permitted only in machine mode.

MP_setToolPlace

Tool pocket preset by the PLC

Available from NCK software version: 597 110-04.

Max. 500 characters

Symbolic variable name under which the PLC can define a tool

pocket, which is then inserted by the user interface and

7.11 Additional Parameters for Lathes