HEIDENHAIN MANUALplus 620 Technical Manual page 1565

Hide thumbs Also See for MANUALplus 620:

January 2012

Function is output in a separate strobe

Selection menu

Use the parameter MP_singular to prevent the function from

being output in a strobe together with other functions.

If several M, S, T functions are programmed in an NC block, the

strobes can be set in parallel by the NC. With this parameter,

you can exclude the current function from this parallel collection

and simultaneous transmission in one strobe.

Function is output in a separate strobe. Combined output is

Function can be combined with other functions

Numbers of functions whose effect will be canceled by the

output of the strobe.

Available from NCK software version: 597 110-02.

Array [0...19]

In the list, enter the numbers of the functions whose effect will

be canceled when this code is output.

Example – Configuration of function M5: Calling function M5

cancels the effect of functions M3 and M4. In this example, you

would enter the key names of the functions M3 and M4.

The parameter is effective for updating the status of the

function in the status display and during block scan.

S outputs for the same spindle as well as T outputs and T2

outputs always cancel each other. However, in some cases

they may also cancel other M functions. M functions cannot

cancel the effects of S, T and T2 outputs.

If specific codes cancel each other, they cannot be combined in

No entry, value optional

Parameter MP_blockSearch is used to define the behavior of the S function

during block scan:

8.7 S Function (S Strobe)