HEIDENHAIN MANUALplus 620 Technical Manual page 1554

Hide thumbs Also See for MANUALplus 620:

Execution at the

beginning or end of

Output of M code

during block scan

In MP_singular, M codes to be output in a separate strobe are defined.

Function is output in a separate strobe

Selection menu

Use the parameter MP_singular to prevent the function from

being output in a strobe together with other functions.

If several M, S, T functions are programmed in an NC block, the

strobes can be set in parallel by the NC. With this parameter,

you can exclude the current function from this parallel collection

and simultaneous transmission in one strobe.

Function is output in a separate strobe. Combined output is

Function can be combined with other functions

In MP_blockEnd, you define whether the M function is to be executed at the

beginning or end of block.

Function output at block end

Selection menu

Function is executed at block end.

Function is executed at beginning of block.

Use the parameter MP_blockSearch to define whether the M code should

also be output during the block scan.

MP_blockSearch

Function output also during block scan

Available from NCK software version: 597 110-02.

Selection menu

Function is also output during the block scan.

Function is not output during the block scan. The function is

collected and restored.

HEIDENHAIN Technical Manual MANUALplus 620