HEIDENHAIN MANUALplus 620 Technical Manual page 1592

System tables
1592
The write-protected directory SYS:\table contains the control's system
tables.
In the conv1.hc table, converted G and M functions are assigned to the
original G and M functions (e. G. for rear-side machining). The conversion list
is assigned to a tool holder by entering the number of the conversion list in
MP_convTblNr (e.g. MP_convTblNr = 1 for conv1.hc).
The inverter.inv table contains important parameters of the power modules
(see "Entries in the power module table (inverter.inv)" on page 1078).
Note
The power module table of older HEIDENHAIN contouring controls,
motor.amp, is no longer supported by the control!
The supply.spy table contains important parameters of the supply modules
(see "Entries in the power supply module table: (supply.spy)" on page 1077).
JhNcError.pet error message table
The HEIDENHAIN standard motor table, MOTOR.MOT, contains important
motor parameters (see "Entries in the motor table (motor.mot)" on page
1078).
Table name
conv1.hc
inverter.inv
JhNcError.pet
MOTOR.MOT
simu.hsi
supply.spy
Group Meaning
SYS Heidenhain conversion list for M and
G functions
Power module table
PLC error message list
Motor data
Colors, chucking equipment (not for
MANUALplus 620)
Supply module table
HEIDENHAIN Technical Manual MANUALplus 620