HEIDENHAIN MANUALplus 620 Technical Manual page 1564

1564
MP_badSpeed
Symbolic name or number of the PLC marker for impermissible
spindle speeds
Available from NCK software version: 597 110-01.
Format: String
Input: Name of the PLC marker which is set if the spindle speed is
outside the permissible range.
No entry: The spindle speed is not monitored.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RESET
MP_cuttingSpeed
Symbolic name or number of the PLC word for transmitting the
constant cutting speed
Available from NCK software version: 597 110-01.
Format: String
Input: Name of the PLC word in which the constant cutting speed is
transmitted to the PLC.
If the parameter is missing, the constant cutting speed cannot
be read as a numerical value.
Default:
Access: LEVEL3
Reaction: RESET
MP_spindleMode
Symbolic name or number of the PLC word for transmission of
the spindle mode of rotation (96 for constant spindle speed, 97
for constant cutting speed). Depending on the value of the PLC
operand defined in MP_spindleMode, the PLC evaluates either
the content of MP_spindleSpeed or MP_cuttingSpeed.
Available from NCK software version: 597 110-01.
Format: String
Input: Name of the PLC word in which the spindle mode of rotation is
transmitted to the PLC
If the parameter is missing, the constant cutting speed cannot
be read as a numerical value.
Default:
Access: LEVEL3
Reaction: RESET
In MP_singular, the S codes that must be output in a separate strobe and
must not be combined with other codes are defined.
HEIDENHAIN Technical Manual MANUALplus 620