Table of Contents
Advertisement
Note
100Gbps transceivers for the AT-XEM2-1CQ Line Card have
handles. Always use the handles when installing or removing
transceivers.
4. Use a #2 Phillips-head screwdriver to loosen the two screws on the
faceplate of the card. Refer to Figure 90.
Figure 90. Loosening the Screws on the Ethernet Line Card
5. Carefully pull on the screws on the faceplate to disconnect the line
card from the internal connector in the switch. Refer to Figure 91 on
page 186.
x950 Series Installation Guide for VCStack
185
Advertisement
Table of Contents
