Allied Telesis AlliedWare Plus x950 Series Installation Manual page 51

x950 Series Installation Guide for VCStack
You must include the PORT parameter when identifying individual ports,
and omit it from the last port when specifying ranges. Here are examples
of the PORT parameter in the INTERFACE command for switches in a
stack. The first example enters the port Interface mode for base port 11 in
a switch with ID 1:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11
This example enters the port Interface mode for base port 4 to 7 in a
switch with ID 2:
awplus(config)# interface port2.0.4-2.0.7
This example enters the port Interface mode for ports 2 and 5 in an XEM2
line card in a switch with ID 1:
awplus(config)# interface port1.1.2,port1.1.5
This example enters the port Interface mode for base port 6 as well as port
5 on an XEM2 line card in a switch with ID 2:
awplus(config)# interface port2.0.6,port2.1.5
This example enters the port Interface mode for base port 10 in a switch
with ID 1 and base port 18 in a switch with ID 2:
awplus(config)# interface port1.0.10,port2.0.18
For further instructions, refer to the Software Reference for x950 Switch,
AlliedWare Plus Operating System.
51