Installing the Plywood Base
A plywood base is recommended when installing the switch on a wall that
has wooden studs. Refer to "Plywood Base for a Wall with Wooden Studs"
on page 121. Consult a qualified building contractor for installation
instructions for the plywood base. The installation guidelines are listed
here:
You should use a stud finder to identify the middle of studs and hot
electrical wiring in the wall.
You should attach the base to two wall studs with a minimum of
four screws.
The selected wall location for the base should adhere to the
recommendations in "Choosing a Site for the Chassis" on page 84
and "Recommended Minimum Wall Area Dimensions" on
page 119.
x950 Series Installation Guide for VCStack
125