Table of Contents
Advertisement
x950 Series Installation Guide for VCStack
Plywood Base for a Wall with Wooden Studs
If you are installing the switch on a wall that has wooden studs, Allied
Telesis recommends using a plywood base for the device. (A plywood
base is not required for a concrete wall.) Refer to Figure 69.
Wall Studs
Wall
Plywood Base
Figure 69. Switch on the Wall with a Plywood Base
The plywood base allows you to mount the switch on two wall studs.
Without the base, only one side of the switch would be attached to a stud.
This is because the standard distance between two studs in a wall is 41
centimeters (16 inches) while the distance between the left and right
brackets on the switch is 37 centimeters (14 1/2 inches).
121
Advertisement
Table of Contents
