Allied Telesis AlliedWare Plus x950 Series Installation Manual page 160

Chapter 9: Configuring Member Switches
Table 28. Configuring a Member Switch - Part I (Continued)
Step
12 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
13 Type "Y" for yes.
14 Wait two minutes for the switch to initialize its management software.
15 Check the ID LED on the front panel and do one of the following:
- If the ID LED is displaying the ID number you assigned to the switch, VCStack is
now enabled on the switch. Go to "Configuring a Member Switch - Part II" on
page 161.
- If the ID LED is displaying the wrong ID number for the switch, repeat this
procedure. Be sure to correctly enter the STACK RENUMBER command and to
save your changes with the WRITE command.
- If the ID LED is displaying "0," VCStack is still disabled. Repeat this procedure. Be
sure to perform the STACK ENABLE command and to issue the WRITE command.
160
Description and Command