Table of Contents
Advertisement
Table 26. Configuring the Master Switch- Part II (Continued)
Step
6
Designate the ports as trunk ports with the STACKPORT command.
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
7
Return to the Global Configuration mode.
awplus(config-if)# exit
Steps 8 designates the types of transceivers to be used in ports 25, 29, 33, and 37 on the
provisioned member switches. The ports support 40Gbps QSFP+ transceivers, 100Gbps
QSFP28 transceivers, and 40Gbps to 10Gbps breakout cables. The default is 40Gbps QSFP+
transceivers.
8
Configure ports 25, 29, 33, and 37 on the provisioned member switches for the
appropriate transceivers, with the PLATFORM PORTMODE INTERFACE command.
For more information, refer to "Ports 25 to 37" on page 26 and "PLATFORM
PORTMODE INTERFACE" on page 134.
This example assumes a stack with three member switches (port2 to port4) that will
use 100Gbps transceivers in ports 33 and 37:
awplus(config)# platform portmode interface port2.0.33-2.0.37 100g
awplus(config)# platform portmode interface port3.0.33-3.0.37 100g
awplus(config)# platform portmode interface port4.0.33-4.0.37 100g
Steps 9 and 10 designate the stack ports on the provisioned switches with the STACKPORT
command.
9
Enter the port Interface modes of the ports that will be the stack trunk on the
provisioned member switches. This example assumes the stack will have three
member switches and the stack ports are 33 and 37. Be sure to modify the command
to specify the ports for your stack trunk.
awplus(config)# interface port2.0.33-2.0.37,port3.0.33-3.0.37,
port4.0.33-4.0.37
10
Designate the ports as trunk ports with the STACKPORT command.
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
Steps 11 to 17 save your changes and reboot the switch.
11
Return to the Global Configuration mode.
awplus(config-if)# exit
Description and Command
x950 Series Installation Guide for VCStack
149
Advertisement
Table of Contents
