Table of Contents
Advertisement
Chapter 4: Installing Power Supplies and Optional XEM2 Line Card
102
4. When the line card makes contact with the internal connector in the
switch. gently press on the sides of its faceplate to seat it on the
connector. Refer to Figure 54.
Figure 54. Seating the Ethernet Line Card in the Expansion Slot
5. Visually inspect the line card to verify that its faceplate is flush against
the front panel of the chassis.
6. Tighten the two captive screws on the card to secure it in the switch.
Refer to Figure 55 on page 103.
Advertisement
Table of Contents
