Table of Contents
Advertisement
3. Place the bumper foot onto one of the holes in the base of the switch.
Refer to Figure 59.
Figure 59. Placing the Bumper Foot on a Base Corner Hole
4. Insert the rivet to secure the bumper foot to the base. Refer to
Figure 60.
Figure 60. Inserting the Rivet into the Bumper Foot
5. Repeat steps 2 to 4 to install the remaining bumper feet.
6. Turn the switch over and place it on a flat, secure desk or table, leaving
ample space around it for ventilation.
7. Do one of the following:
To install power supplies, go to "Installing AT-PWR600 AC Power
x950 Series Installation Guide for VCStack
107
Advertisement
Table of Contents
