Table of Contents
Advertisement
Chapter 8: Configuring the Master Switch
Powering On a Switch
138
To power on the switch, perform the following procedure:
1. Connect the AC power cord included with the power supply to the AC
power connector on the rear panel of the chassis. If the switch has two
power supplies, you only need to power on one of them to configure
the switch. Refer to Figure 75.
Figure 75. Connecting the AC Power Cord
2. Move the power cord into the restraining strap and secure the strap by
feeding it into the tab slot. Refer to Figure 76 on page 139.
Advertisement
Table of Contents
