At+Qideact Deactivate Gprs/Csd Pdp Context - Quectel M35 Command Manual

was set as 1 (refer to AT+QIMUX). When AT+QIMUX was set as 0, the parameter MUST
be omitted
NOTES
1. Execution Command AT+QICLOSE:
 If QISRVC is 1 (please refer to AT+QISRVC) and QIMUX is 0 (please refer to AT+QIMUX), this
command will close the connection in which the module is used as a client.
 If QISRVC is 1 and QIMUX is 1, it will return ERROR.
 If QISRVC is 2 and QIMUX equals 0 and the module is used as a server and some clients have
been connected to it, this command will close the connection between the module and the
remote client.
 If QISRVC is 2 and QIMUX is 0 and the module is in listening state without any client, this
command will cause the module to quit the listening state.
 If QISRVC is 2 and QIMUX is 1 and the module is used as a server, this command will close all
the income connection and cause the module to quit the listening state.
2. Write Command AT+QICLOSE=<index>:
 This command is valid only if QIMUX is 1.
 If QISRVC is 1 and QIMUX is 1, this command will close the corresponding connection
according to <index> and the module used as a client in the connection.
 If QISRVC is 2 and QIMUX is 1, this command will close the incoming connection according to
<index>.
3. If QISRVC is 1 and QIMUX is 0, AT+QICLOSE only closes the connection when the statue is
CONNECTING or CONNECT OK, otherwise respond with ERROR. After closing the connection, the
status is IP CLOSE.

11.4. AT+QIDEACT Deactivate GPRS/CSD PDP Context

AT+QIDEACT Deactivate GPRS/CSD PDP Context
Test Command
AT+QIDEACT=?
Execution Command
AT+QIDEACT
Reference
M35_AT_Commands_Manual
Response
OK
Response
If close succeeds:
DEACT OK
If close fails:
ERROR
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
126 / 186