Quectel M35 Command Manual page 97

1
2
3
<bm> (The rules for storing received CBMs depend on its data coding scheme (refer to GSM
03.38 [2]), the setting of Select CBM Types (+CSCB) and this value):
0
2
3
<ds> 0
1
<bfr> 0
NOTE
Unsolicited result code
+CMTI: <mem>,<index>
+CMT: [<alpha>],<length><CR><LF><pdu>
+CBM: <length><CR><LF><pdu>
Example
AT+CMGF=1
OK
AT+CSCS="GSM"
OK
AT+CNMI=2,1
M35_AT_Commands_Manual
If SMS-DELIVER is stored into ME/TA, indication of the memory location is routed
to the TE by using unsolicited result code: +CMTI: <mem>,<index>
SMS-DELIVERs (except class 2) are routed directly to the TE using unsolicited
result code: +CMT: [<alpha>],<length><CR><LF><pdu> (PDU mode enabled)
or +CMT: <oa>, [<alpha>],<scts>
[,<tooa>,<fo>,<pid>,<dcs>,<sca>,<tosca>,<length>]<CR><LF><data>
(Text mode enabled; about parameters in italics, refer to Command Show Text
Mode Parameters +CSDH). Class 2 messages result in indication as defined in
<mt>=1
Class 3 SMS-DELIVERs are routed directly to TE by using unsolicited result
codes defined in <mt>=2. Messages of other classes result in indication as
defined in <mt>=1
No CBM indications are routed to the TE
New CBMs are routed directly to the TE by using unsolicited result code: +CBM:
<length><CR><LF><pdu> (PDU mode enabled) or +CBM:
<sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data> (Text mode enabled)
Class 3 CBMs are routed directly to TE by using unsolicited result codes defined
in <bm>=2. If CBM storage is supported, messages of other classes result in
indication as defined in <bm>=1
No SMS-STATUS-REPORTs are routed to the TE
SMS-STATUS-REPORTs are routed to the TE by using unsolicited result code:
+CDS: <length><CR><LF><pdu> (PDU mode enabled) or +CDS:
<fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st> (Text mode enabled)
TA buffer of unsolicited result codes defined in this command is flushed to the TE
when <mode> 1...3 is entered (OK response shall be given before flushing the
codes)
Indicates that new message has been received
Short message is output directly
Cell broadcast message is output directly
// Set SMS message format as text mode
// Set character set as GSM which is used by the TE
// SMS-DELIVER is stored into ME/TA, indication of the
memory location is routed to the TE
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
97 / 186