Quectel M35 Command Manual page 132

Parameter
<state> A string parameter to indicate the status of the connection
When AT+QIMUX=0:
"IP INITIAL"
"IP START"
"IP CONFIG"
"IP IND"
"IP GPRSACT"
"IP STATUS"
"TCP CONNECTING" It is trying to establish a TCP connection
"UDP CONNECTING" It is trying to establish a UDP connection
"IP CLOSE"
"CONNECT OK"
"PDP DEACT"
When AT+QIMUX=1:
"IP INITIAL"
"IP START"
"IP CONFIG"
"IP IND"
"IP GPRSACT"
"IP STATUS"
"IP PROCESSING"
"PDP DEACT"
<index> The index of the connection, the range is (0-5)
<mode> The type of the connection
"TCP"
"UDP"
<addr> The IP address of the remote
<port> The port of the remote
<socketstate> A string parameter to indicate the status of the access connection, including
INITIAL,CONNECTED
M35_AT_Commands_Manual
The TCPIP stack is in idle state
The TCPIP stack has been registered
It has been start-up to activate GPRS/CSD context
It is activating GPRS/CSD context
GPRS/CSD context has been activated successfully
The local IP address has been gotten by the command
AT+QILOCIP
The TCP/UDP connection has been closed
The TCP/UDP connection has been established successfully
GPRS/CSD context was deactivated because of unknown
reason
The TCPIP stack is in idle state
The TCPIP stack has been registered
It has been start-up to activate GPRS/CSD context
It is activating GPRS/CSD context
GPRS/CSD context has been activated successfully
The local IP address has been gotten by the command
AT+QILOCIP
Data phase. Processing the existing connection now
GPRS/CSD context was deactivated because of unknown
reason
TCP connection
UDP connection
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
132 / 186