Quectel M35 Command Manual page 43

"FN"
"MW"
"UR"
"BC"
"BM"
"SM"
"CC"
<mode> 0
1
2
M35_AT_Commands_Manual
to AT+CSQ) in form +CSQN: <rssi>, <ber>when values change.
Forbidden network available only. When returning to a non-registered state, this
indicates whether all the available PLMNs are forbidden.
SMS Message waiting. On receiving an SMS (as indicated by the +CMTI
indication) the SMS is decoded and checked to see if it contains one or more of
the message waiting indications (i.e. voicemail, email, fax etc). If so, an unsolicited
indication is shown in the form for each message type:
+QMWT: <store>,<index>,<voice>,<fax>,<email>,<other>. Where <store>
is the message store containing the SM, index is the message index and <voice>,
<email>, <fax>, <other> contain the number of waiting messages (with „0‟
defined as clear indication, non-zero for one or more waiting messages) or blank
for not specified in this message.
Unsolicited result code. Produces an unsolicited indication in the following call
state transition. Multiple notifications may occur for the same transition +QGURC:
<event>. Where <event> describes the current call state:
<event>:
0 Terminated active call, at least one held call remaining
1 Attempt to make an Mobile Originated call
2 Mobile Originated Call has failed for some reason
3 Mobile Originated call is ringing
4 Mobile Terminated call is queued (Call waiting)
5 Mobile Originated Call now has been connected
6 Mobile Originated or Mobile Terminated call has been disconnected
7 Mobile Originated or Mobile Terminated call hung up.
8 Mobile Originated call dialed a non-emergency number in emergency
mode
9 No answer for mobile Originated call
10 Remote number busy for Mobile Originated call
Battery Charge. Displays battery connection status and battery charge level
(similar to AT+CBC) in form +CBCN:<bcs>,<bcl> when values change.
Band mode. Displays band mode (similar to AT+QBAND) in form +QBAND:
<band> when value changes.
Additional SMS Information. Displays additional information about SMS events in
the form of Unsolicited messages of the following format +TSMSINFO: <CMS
error info> where <CMS error info> is a standard CMS error in the format
defined by the AT+CMEE command i.e. either a number or a string.
Call information. Displays the disconnected call ID and the remaining call
numbers after one of the call is disconnected. +CCINFO: <Call id
disconnected>,<Remain calls>
Disable
Enable
Query
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
43 / 183