At+Ilrr Set Te-Ta Local Data Rate Reporting Mode - Quectel M35 Command Manual

OK

3.5. AT+ILRR Set TE-TA Local Data Rate Reporting Mode

AT+ILRR Set TE-TA Local Data Rate Reporting Mode
Test Command
AT+ILRR=?
Read Command
AT+ILRR?
Write Command
AT+ILRR=[<value>]
Reference
V.25ter
Parameter
<value> 0
1
NOTE
If the <value> is set to 1, the following intermediate result will come out on connection to indicate the port
rate settings.
+ILRR:<rate>
<rate> Port rate setting on call connection in Baud per second
300
1200
2400
4800
9600
14400
19200
28800
M35_AT_Commands_Manual
Response
+ILRR: (list of supported <value>s)
OK
Response
+ILRR: <value>
OK
Response
This parameter setting determines whether or not an
intermediate result code of local rate is reported when the
connection is established. The rate is applied after the final
result code of the connection is transmitted to TE.
OK
Disables reporting of local port rate
Enables reporting of local port rate
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
34 / 186