At+Qimux Control Whether Or Not To Enable Multiple Tcpip Session - Quectel M35 Command Manual

Reference
Parameter
<mode> 0
1
NOTE
This command is invalid if QIHEAD was set as 0 by the command AT+QIHEAD=0.
11.26. AT+QIMUX Control Whether or not to Enable Multiple TCPIP
Session

AT+QIMUX Control Whether or not to Enable Multiple TCPIP Session

Test Command
AT+QIMUX=?
Read Command
AT+QIMUX?
Write Command
AT+QIMUX=<mode>
Reference
Parameter
<mode> 0
1
M35_AT_Commands_Manual
ERROR
DO NOT show the transport protocol type at the end of header of the received
TCP/UDP data
Show the transport protocol type at the end of header of the received TCP/UDP
data as the following format.IPD(data length)(TCP/UDP):
Response
+QIMUX: (list of supported <mode>s)
OK
Response
+QIMUX: <mode>
OK
Response
OK
ERROR
DO NOT enable multiple TCPIP session at the same time
Enable multiple TCPIP session at the same time
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
145 / 186