At+Qistat Query Current Connection Status - Quectel M35 Command Manual

11.9. AT+QISTAT Query Current Connection Status

AT+QISTAT Query Current Connection Status
Test Command
AT+QISTAT=?
Execution Command
AT+QISTAT
Reference
Parameter
<state> A string parameter to indicate the status of the connection
"IP INITIAL"
"IP START"
"IP CONFIG"
"IP IND"
"IP GPRSACT"
"IP STATUS"
"TCP CONNECTING"
"UDP CONNECTING"
"IP CLOSE"
"CONNECT OK"
"PDP DEACT"
If ATV was set to 0 by the command ATV0, the TCPIP stack gives the following numeric to
indicate the former status
0
1
2
3
4
5
M35_AT_Commands_Manual
Response
OK
Response
When AT+QIMUX=0, respond
OK
STATE: <state>
When AT+QIMUX=1, respond
List of
(+QISTAT: <index>,<mode>,<addr>,<port><CR><LF>)
OK
The TCPIP stack is in idle state
The TCPIP stack has been registered
It has been start-up to activate GPRS/CSD context
It is activating GPRS/CSD context
GPRS/CSD context has been activated successfully
The local IP address has been gotten by the command
AT+QILOCIP
It is trying to establish a TCP connection
It is trying to establish a UDP connection
The TCP/UDP connection has been closed
The TCP/UDP connection has been established successfully
GPRS/CSD context was deactivated because of unknown
reason
"IP INITIAL"
"IP START"
"IP CONFIG"
"IP IND"
"IP GPRSACT"
"IP STATUS"
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
130 / 186