At+Qimode Select Tcpip Transfer Mode; At+Qitcfg Configure Transparent Transfer Mode - Quectel M35 Command Manual

AT+QIFGCNT).
3. CSD configuration is not supported at present.

11.23. AT+QIMODE Select TCPIP Transfer Mode

AT+QIMODE Select TCPIP Transfer Mode
Test Command
AT+QIMODE=?
Read Command
AT+QIMODE?
Write Command
AT+QIMODE=<mode>
Reference
Parameter
<mode> 0
1

11.24. AT+QITCFG Configure Transparent Transfer Mode

AT+QITCFG Configure Transparent Transfer Mode
Test Command
AT+QITCFG=?
Read Command
M35_AT_Commands_Manual
Response
+QIMODE:(0-NORMAL MODE,1-TRANSPARENT MODE)
OK
Response
+QIMODE: <mode>
OK
Response
OK
ERROR
Normal mode. In this mode, the data should be sent by the command
AT+QISEND
Transparent mode. In this mode, UART will enter data mode after TCP/UDP
connection has been established. In data mode, all input data from UART will be
sent to the remote end. +++ can help to switch data mode to command mode. And
then ATO can help to switch command mode to data mode
Response
+QITCFG: (list of supported <NmRetry>s),(list of supported
<WaitTm>s),(list of supported <SendSz>s),(list of supported
<esc>s)
OK
Response
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
143 / 186