Ats7 Set Number Of Seconds To Wait For Connection Completion - Quectel M35 Command Manual

Write Command
ATS6=<n>
Reference
V.25ter
Parameter
<n> 0-2-10
NOTE
No effect in GSM

7.9. ATS7 Set Number of Seconds to Wait for Connection Completion

ATS7 Set Number of Seconds to Wait for Connection Completion
Read Command
ATS7?
Write Command
ATS7=<n>
Reference
V.25ter
Parameter
<n> 1-60-255
NOTES
1. If called party has specified a high value for ATS0=<n>, call setup may fail.
2. The correlation between ATS7 and ATS0 is important, for example: Call may fail if ATS7=30 and
ATS0=20.
3. ATS7 is only applicable to data call.
M35_AT_Commands_Manual
Response
OK
Number of seconds to wait before blind dialing
Response
<n>
OK
Response
This parameter setting determines the amount of time to wait
for the connection completion in case of answering or
originating a call.
OK
Number of seconds to wait for connection completion
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
69 / 186