Table of Contents
Advertisement
install the prerequisite software and/or set up the shared memory. Then, enable the license key. See the
following table for details.
Causes
The prerequisite software was not installed before
the license key software was installed.
The shared memory was not set up before the
following license key software was installed.
•
Auto LUN
•
Continuous Access Synchronous and
Continuous Access Synchronous Z
•
Continuous Access Journal and Continuous
Access Journal Z
•
Compatible FlashCopy
•
Compatible FlashCopy SE
•
Business Copy and Business Copy Z
•
Smart Tiers and Smart Tiers Z
Enabling or disabling a license
The term key can be enabled or disabled. You can also enable a license when you install more than one
software product. However, some software may not be available because the requirements for these
products are not satisfied. When this is the case, satisfy the requirements first, then enable the license.
Procedure
1. Click Settings > Install > License Key > . The License Key window opens.
2. Click
to change to Modify mode.
3. Select the software from the list.
4. In License Status, select Enable or Disable.
5. Click Set. The Status column changes to Install or Install (Disabled).
6. Click Apply. The status changes.
Removing software
Procedure
1. Click Settings > Install > License Key. The License Key window opens.
2. Click
to change to Modify mode.
3. Select the desired option that you want to remove from the list.
4. From Mode, click Key Code.
Recommended Actions
Install the required prerequisite software. See
Software and licensed capacity on page 79.
Set up the shared memory, and then, enable the
license. See Enabling or disabling a license on
page 85.
License keys
85
Advertisement
Table of Contents
