Table of Contents
Advertisement
Item
SMTP-AUTH
Account
andPassword
From Address
Return Address
To Address
Test Send
Apply
Cancel
Report Display dialog box
264
Remote Web Console GUI reference (secondary windows)
Description
Specify whether to use SMTP authentication.
•
Enable: Uses SMTP authentication.
•
Disable: Does not use SMTP authentication.
Set the account and password for SMTP authentication. Required when SMTP-
AUTH is Enable. Enter up to 255 alphanumeric characters and symbols (ASCII
codes) for user ID and password, except for the following symbols and a space:"
\ ; : , * ? < > | / # and + = [ ] ' { } ^
Specify an e-mail address of the sender. Enter up to 255 alphanumeric characters
(ASCII codes) and symbols: ( ! # $ % and ` + - * / ^ { } _ . ).
Specify a Reply-To address of e-mail. If you specify this address, replies from the e-
mail receivers will be sent to this address. If you omit this address, replies from the
e-mail receivers will be sent to From Address. The available values are the same as
those of From Address.
Specify e-mail addresses of the receivers and the attributes (To, Cc, or Bcc). Up to
32 addresses can be specified. The available values are the same as those of From
Address.
When you click Test Send, test e-mails are sent to the e-mail addresses of the
receivers. This button is available only in Modify mode.
Implements all the settings. This button is available only in Modify mode.
Cancels all the settings. This button is available only in Modify mode.
Advertisement
Table of Contents
