Table of Contents
Advertisement
Importing the certificate to the SVP
If you use a self-signed certificate, the Web browser displays a warning message when it connects to an
SSL-enabled SVP. You can disable this message using the following sample procedure, which assumes
the use of Internet Explorer
To import the certificate to the browser:
Procedure
1.
Log on to the Remote Web Console SVP using a secure connection (specify the URL using https).
The Security Alert dialog box appears.
2.
Click Continue to this website (not recommended) in the Security Alert dialog box.
3.
Click the Page > Security Report > Certificate Invalid.
The subsequent dialog box appears.
4.
Click View certificates.
5.
Click the General tab in the Certificate window.
6.
Click Install Certificate (I) .
The Welcome window of the Certificate Import Wizard appears.
7.
Click Next.
The Certificate Store window of the wizard appears.
8.
Select Automatically select the certificate store based on the type of certificate, and click Next.
The completion window appears.
9.
Click Finish.
If the import was successful, the confirmation window appears.
10. Click OK.
Disabling TLSv1.0 and TLSv1.1 communications
To enhance security, you can disable TLSv1.0 and TLSv1.1 communications and use only TLSv1.2.
If you want to disable TLSv1.0 and TLSv1.1 communications, contact Hewlett Packard Enterprise
technical support.
NOTE:
•
JRE6.0 does not support TLSv1.2. Use JRE7.0 or later. JRE8.0 or later is recommended.
•
Your Web browser might not support TLSv1.2. In this case, use a web browser that supports TLSv1.2.
For details about supported web browser versions, contact Hewlett Packard Enterprise technical
support.
•
If you disable TLSv1.0 and TLSv1.1 communications, pages might not be displayed correctly
depending on the TLS setting. Enable Use TLS 1.2 of the browser.
Enabling TLSv1.0 and TLSv1.1 communications
You can enable the disabled TLSv1.0 and TLSv1.1 communications.
®
8.0.
Setting up Remote Web Console
19
Advertisement
Table of Contents
