Table of Contents
Advertisement
3. Enter the user ID and password, and click Login.
4. Click the Set Env. tab to open the Set Env. dialog box.
5. Specify the Remote Web Console parameters as required.
6. Click Submit.
7. Click Exit (
8. Log out of the Remote Web Console SVP, and then, log in again to make the new parameters take
effect.
9. Back up the Remote Web Console configuration file by downloading the file from the SVP.
Remote Web Console environment parameters are described in the following table:
Table 16: Environment parameters
Item
RMI time-out
period
RMI time-out
period for Modify
70
Configuring the Remote Web Console environment
) to close the Control Panel.
Description
If the user cannot access the SVP for a certain period of time because of a network
error, the RMI time-out logs the user out of the SVP.
•
The value of the RMI time-out period must be greater than the value set for the
smallest polling period, either for checking exclusive lock or for checking
obstacles (see below for those parameters). For example, specify a value of the
RMI time-out period to satisfy the following condition:RMI time-out period > min
[A, B]where
A = Polling period for checking exclusive lock
for checking obstacles, and min [A, B] indicates the minimum value selected
from A and B.
•
The default is 1 minute. You can specify 1 minute, 5 – 60 minutes in 5-minute
increments, 70 to 120 minutes in 10-minute increments, or one day (24 hours).
•
This parameter cannot be disabled.
If a user is in Modify mode but does not make any changes that access the RMI
server for a specified period of time, Modify mode is released, and the View mode
appears.
•
The default time period is 30 minutes. You can specify between 10 and 60
minutes in 10-minute increments, or between 120 and 360 minutes in 60-minute
increments.
•
Specify NO to disable this parameter.
B = Polling period
Table Continued
Advertisement
Table of Contents
